Stoelting E112 Manuel d'utilisateur

Model E112OWNER’S MANUALManual No. 513613 Rev.1 October, 2006

42.2 SHIPMENT AND TRANSITThe freezer has been assembled, operated and inspectedat the factory. Upon arrival at the final destination, the entirefreeze

5Figure 3-1 Freezer Controls3.1 OPERATOR’S SAFETY PRECAUTIONSSAFE OPERATION IS NO ACCIDENT; observe theserules:A. Know the freezer. Read and understan

6B. CLEAN-OFF-ON SwitchThe CLEAN-OFF-ON switch is used to supplypower to the control circuit. When the switch is inthe OFF (middle) position, power wi

7E. After five minutes, place a bucket under the spigotand open spigot to drain sanitizing solution. Placethe switch in the OFF (middle) position. Loo

8A. Close the spigot and fill the hopper with 2 gallons(8 liters) of tap water.B. Place the switch in the CLEAN position. The augerwill start to rotat

9L. Remove auger assembly from the freezing cylinderand remove auger blades.M. Remove rear seal and o-ring from auger.N. Remove drain tray, drip tray

10D. Install the two plastic auger blades onto auger.Blades may be attached in any orientation.E. Push auger into freezing cylinder and rotate slowlyu

11regulator is not required.P. Install hopper cover, drain tray, drip tray, and driptray grid.3.12 ROUTINE CLEANINGTo remove spilled or dried mix from

12• MILKSTONE REMOVAL – Complete removal ofmilkstone.• SANITIZING – FDA-approved no rinse sanitizer forfood contact surfaces.Additional InformationTHE

132. To remove the condenser filter, remove the thumbscrews from under the front panel. Pull downbracket and remove filter. Visually inspect for dirt.

14This page left intentionally blank

15SECTION 4TROUBLESHOOTING4.1 MIX LIGHT INDICATORSThe following chart shows all possible mix light indicator combinations along with the cause and ope

164.2 TROUBLESHOOTING - CONTINUEDPROBLEM POSSIBLE CAUSE REMEDYProduct is too soft.1. No vent space for free flow of cooling air.2. Air temperature ent

17SECTION 5REPLACEMENT PARTS5.1 HOW TO ORDER PARTSTo assure receipt of the proper replacement parts, supplyyour dealer or distributor with the followi

18E112 REPLACEMENT PARTS

19E112 REPLACEMENT PARTSPart Description Qty162165 Scraper Blade 2336546 Molded Door 1482019 Black Knob 4570196 Pin - Door 1624545 O-Ring - Stator Bar

WARRANTYSOFT SERVE / SHAKE FREEZERS1. Scope: Stoelting, LLC warrants to the first user (the “Buyer”) that the freezer cylinders, hoppers, compr

This manual provides basic information about the freezer. Instructions and suggestions are givencovering its operation and care.The illustrations and

Safety Alert Symbol:This symbol Indicates danger, warning or caution.Attention is required in order to avoid serious personalinjury. The message that

SECTION DESCRIPTION PAGE1. INTRODUCTION1.1 Description...

LIST OF ILLUSTRATIONSFIGURE TITLE PAGE1-1 Model E112 Freezer ...

1Figure 1-2 Freezer SpecificationsSECTION 1DESCRIPTION AND SPECIFICATIONS1.1 DESCRIPTIONThe Stoelting E112 counter freezer is gravity fed. Thefreezer

2MODEL E112COUNTER MODELGRAVITY FREEZERDIMENSIONS:Freezer: 15-1/4" (33.8 cm) wide x 31-15/16" (81.1 cm) deep x 30-3/8" (77.2 cm) highCr

32.1 SAFETY PRECAUTIONSDo not attempt to operate the freezer until the safetyprecautions and operating instructions in this manual areread completely